Universal Cab Setting

Start with three pieces of wire, each 18 inches long.  Bend one in half

using round nose pliers.

Hook the bent wire around the middle of the other two wires. 

Bend one end around so that the bend wire forms a complete loop around the pair

of wires.  Use your pliers to squeeze the loop shut so that it is snug.

Take your cab and place the "X" you have made over the center of the flat side

of the cab as shown.  Two of the arms should have two wires and two of the arms should

have one wire.  Make sure that the longer ends of the cab (top and bottom here) lie

between two of the arms.

Continue